Cutting and Condensing Gutta-Percha
Use Ultrasonics to cut and condense gutta percha with excellent results.
The most common technique to cut and condense Gutta-Percha requires the use of expensive heating instruments. These may cost thousands of dollars and have no use in other daily procedures. A simple, fast and inexpensive way to do it is using ultrasonics – the heat produced by the ultrasonic tip is enough to cut and condense the material. The final results are very similar and the procedure can be done with the same ultrasonic unit already in use in other steps of the treatment.
Step-by-Step Gutta-Percha Cutting and Condensing
1 – need step
2 – need step
3 – need step
Never Use Water
1. Insert the Gutta-Percha cone into the canal.
2. Use an E10 tip to cut the cone. Release the footswitch and immediately condense the cone.
“There is no question about it: the Bladesonic is a very ergonomic tip and performs a clean cut with minimal root structure loss. It is indispensable to any endodontic arsenal.”
Jose Maurício de Camargo, DDS
Starter Packs to get you going.
We’ve assembled three separate starter packs packaged with a procedure field guide to get you started supercharging ultrasonics in your practice.
Endo Starter Pack
The Endo Starter Pack includes 6 Ultrasonics Tips to get you started with Pulp Chamber, Middle Third and Activation procedures.
Endo Master Pack
The Endo Master Pack includes 12 Ultrasonics Tips for Pulp Chamber, Middle Third, Activation, Post Removal and Retreatment procedures.
Endo Guru Pack
The Endo Guru Pack includes 18 Ultrasonics Tips for maximum flexibility with Pulp Chamber, Middle Third, Activation,Post Removal, Apical Surgery and Retreatment procedures.
When purchasing tips we offer savings for every 6 tips you add to your cart. No discount codes just add to your cart and start saving.